41 35 101 Replacing Left Rear Side Panel Stripping Operations
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
High-voltage system - danger to life!
WARNING:
The following points must be strictly observed prior to starting work
:
- DE-ENERGIZE THE HIGH-VOLTAGE SYSTEM
- Observe SAFETY INFORMATION for handling with hybrid cars
NOTE:
Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.
The following list basically represents the removal sequence.
- Disconnect negative battery cable
- Remove bumper trim panel
- Remove bumper support
- Remove center bumper guide
- Remove left bumper guide
- Remove luggage compartment floor trim panel
- Remove left luggage compartment wheel arch panel
- Remove water gutter trim
- Remove trim on tail panel at top
- Remove left rear light
- Partially detach tailgate seal
- Remove rear left door
- Remove left lock striker
- Remove rear left door sill cover strip
- Remove rear left door edge protection
- Remove rear seat
- Remove backrest side section on rear seat backrest
- Remove rear left wheel arch cover
- Remove trim panel for cover on left side member
- Remove trim strip on left roof frame
- Remove rear left side window
- Remove shoulder
- Partially release wiring harness