67 61 005 Removing and installing/renewing drive with gearbox (front) for actuating slide/tilt sunroof

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove ROOF SWITCH CLUSTER

NOTE: Secure drive with gearbox for actuating slide/tilt sunroof (3) against falling out.

Unfasten plug connection (1) and disconnect.

Release screws (2), tightening torque 54 13 1AZ .

NOTE: Screws (2) are microencapsulated.

Remove drive with gearbox for actuating slide/tilt sunroof (3).

Fig 1: Identifying Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert gear wheel (1) of drive with gearbox for actuating slide/tilt sunroof (2) exactly in gear teeth (3).

Fig 2: Identifying Gear Wheel, Actuating Slide/Tilt Sunroof And Gear Teeth

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Initialize SLIDE/TILT SUNROOF .

Replacement:

Carry out VEHICLE PROGRAMMING/ENCODING