67 31 570 Removing and installing/replacing drive for head restraint height adjustment on left or right front seat

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Version without crash-active head restraint:

Remove HEAD RESTRAINT
REMOVE REAR PANEL ON FRONT SEAT BACKREST .

Version with crash-active head restraint:

Remove CRASH-ACTIVE HEAD RESTRAINT

Pull backrest cover (1) in direction of arrow over metal lugs (2) and detach.

Detach backrest cover (1) on both sides from backrest frame.

Feed backrest cover (1) out of upper backrest frame.

Fig 1: Lifting Backrest Cover With Padding In Upper Area Over Backrest Frame

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unfasten screws (2).

Tightening torque 67 31 3AZ .

Feed out drive for head restraint height adjustment (3) in direction of arrow and remove.

Fig 2: Removing Head Restraint Height Adjustment Drive

Courtesy of BMW OF NORTH AMERICA, INC.