67 31 510 Removing and installing/replacing drive unit for seat tilt adjustment

Necessary preliminary tasks:

• Remove FRONT SEAT

Release screws (1).

Tightening torque 52 10 6AZ .

Fold back seat rail (2) slightly from seat frame (3) in direction of arrow.

Fig 1: Folding Back Seat Rail From Seat Frame

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Make sure plastic bushings (1) are correctly seated in seat rail (2).

Faulty plastic bushings (1) cause noises and must be replaced.

Fig 2: Identifying Plastic Bushing And Seat Rail

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) on drive unit for seat tilt adjustment (2).

NOTE: Relieve load on drive unit for seat tilt adjustment (2).
To do so, insert a suitable slotted screwdriver (3) into receptacle (4), press drive unit for seat tilt adjustment (2) downwards slightly using a lever action and release screw (5).

Fig 3: Disconnecting Drive Unit Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque 67 31 2AZ .

Then slowly move screwdriver (3) upwards and relieve load on drive unit for seat tilt adjustment (2) completely.

Tilt drive unit for seat tilt adjustment (1) upwards and feed out from receptacle (2).

If necessary, twist out drive unit for seat tilt adjustment (1) at spindle (3) to such an extent that it can be removed.

Fig 4: Twisting Drive Unit For Seat Tilt Adjustment At Spindle

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Measure dimension (A) and adjust by turning holder (1) on new drive unit for seat tilt adjustment (2).

INITIALIZE  drive unit for seat tilt adjustment.

Fig 5: Identifying Seat Unit Adjuster And Holder

Courtesy of BMW OF NORTH AMERICA, INC.