24 00 057 Installing exchange transmission (GA7AHSCD)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Before replacement, the service function "EWS-TCM adjustment" must be carried out in the BMW diagnosis system.
(Service function/Drive/Hybrid cars/Hybrid transmission/EWS adjustment))

Installation note:

After completion of the work, program the control unit for electronic transmission control (TCM Transmission Control Module).

Drain automatic transmission fluid at oil drain plug (2).

Tightening torque 24 11 4AZ .

Fig 1: Identifying Oil Filler Plug And Oil Drain Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Recycling:

Catch and dispose of escaping transmission oil.

Observe country-specific waste disposal regulations.

Necessary preliminary tasks:

Remove TRANSFER BOX

IMPORTANT:

Before installing exchange transmission, always flush transmission oil cooler together with lines.
After completion of work, CHECK TRANSMISSION OIL LEVEL .
Use only approved transmission oil: Dexron VI automatic transmission fluid (GM)
Failure to comply with this requirement will result in serious damage to the automatic transmission

Exchange transmissions come filled with oil

Modify transportation retainers.

Convert all cable clips.

Convert all seal plugs.

Convert protective cap on output shaft.

Transmission identification:

refer to BMW Parts Service.
On type plate

Fig 2: Identifying Transportation Retainers, Cable Clips And Seal Plugs
Courtesy of BMW OF NORTH AMERICA, INC.