51 34 380 Removing and installing/replacing decorative strip on rear door (top), left or right

WARNING: This page is about a different car, the 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Starting at rear, pull off seal (1) towards front.

Installation:

Moisten seal (1) with water before fitting.

Fig 1: Pulling Off Door Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip decorative strip (1) at retainers (2) in outward direction.

Installation:

If necessary, replace faulty retainers (2).

Make sure decorative strip is correctly seated on all seals.

Fig 2: Removing Decorative Strip At Retainers

Courtesy of BMW OF NORTH AMERICA, INC.