51 23 131 Adjusting left or right striker on engine hood/bonnet

WARNING: This page is about a different car, the 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Adjusting striker is described in:
ADJUSTING ENGINE COMPARTMENT LID .

Release bolts (1) and remove striker (2).

Tightening torque 51 23 3AZ .

Left side only:

Disconnect Bowden cable (3).

Fig 1: Identifying Bowden Cables, Striker And Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

ADJUST ENGINE COMPARTMENT LID