51 71 372 Removing and installing/replacing both trailing links on spring strut domes
WARNING: This page is about a different car, the 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
Release screws (1).
Remove trailing link (2).
IMPORTANT:
To ensure a correct ground connection, use only Original BMW replacement part. Thread repairs on bulkhead console are not permitted.
Replace screws.
Tightening torque 51 71 2AZ .
Replace screws.
Tightening torque 51 71 2AZ .