51 47 491 Removing and installing/replacing rear underbody protection

WARNING: This page is about a different car, the 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Illustration created using X5 3.0i as an example. There may be differences in detail in the case of other models.

Release screws (1) and remove underbody protection (2).

Installation note:

Center underbody protection (2) and tighten down screws (1).

Fig 1: Identifying Underbody Protection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.