36 11 121 Removing and installing/replacing an RDC trigger transmitter (front)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Partially detach front WHEEL ARCH TRIM

Disconnect plug connection (1).

Release plastic nuts (2) and remove trigger transmitter (3).

Installation:

If necessary, replace plastic nuts.

Fig 1: Identifying Plug Connection, Plastic Nuts And Trigger Transmitter

Courtesy of BMW OF NORTH AMERICA, INC.