11 33 054 Removing and installing/renewing rocker arms on right side (N63 hybrid)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

11 4 480

(cylinder bank 1 to 4)

WARNING: High-voltage system - danger to life!

Necessary preliminary tasks:

Remove INLET AND EXHAUST ADJUSTMENT UNIT on right side.
Remove right INLET CAMSHAFT .
Remove right EXHAUST CAMSHAFT .

IMPORTANT: Used rocker arms (1) may only be reused in the same position.
Tolerance classes are not required.

Remove rocker arm (1) and set down in neat order in special tool 11 4 480 .

Install rocker arm (1).

Align all rocker arms (1) straight.

Fig 1: Identifying Rocker Arm

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.