11 33 052 Removing and installing/replacing all rocker arms on left side (N63 hybrid)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

11 4 480

(cylinder bank 5 to 8)

WARNING: High-voltage system - danger to life!

Necessary preliminary tasks:

Remove LEFT INLET CAMSHAFT .
Remove left EXHAUST CAMSHAFT .

IMPORTANT: Used rocker arms (1) may only be reused in the same position.
Tolerance classes are not required.

Remove rocker arm (1) and set down in a tidy and orderly fashion in special tool 11 4 480 .

Install rocker arm (1).

Align all rocker arms (1) straight.

Fig 1: Identifying Rocker Arm

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.