64 11 849 Replacing actuator drive for ram air pressure compensation

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT

Release screws (1) and remove air duct (2).

Fig 1: Identifying Air Duct And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove servomotor (2) and disconnect associated plug connection.

Fig 2: Identifying Servomotor And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Servomotors must be re-addressed in the event of replacement!

Addressing can only be carried out with the BMW diagnosis system.

Service functions:

Body
Heating and air conditioning function
Flap motors
Re-address flap motors