64 53 733 Replacing double pipe
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
WARNING:
Risk of injury!
Refrigerant circuit is under high pressure!
Avoid contact with refrigerant and refrigerant oil.
Read and comply with safety regulations:
Refrigerant circuit is under high pressure!
Avoid contact with refrigerant and refrigerant oil.
Read and comply with safety regulations:
- Follow safety information for handling R134a refrigerant. See SAFETY INFORMATION and INSTRUCTIONS FOR HANDLING .
- HANDLING REFRIGERANT OIL
IMPORTANT:
Risk of damage!
Restart engine only when air conditioning system has been correctly filled.
Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit.
If air conditioning system is opened for more than 24 hours: Replacing DRIER INSERT FOR A/C SYSTEM
Restart engine only when air conditioning system has been correctly filled.
Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit.
If air conditioning system is opened for more than 24 hours: Replacing DRIER INSERT FOR A/C SYSTEM
Necessary preliminary tasks:
- DRAWING OFF A/C SYSTEM (not included in time value of this operation)
Release screw (1).
Installation:
Check that rubber seal is correctly seated.
Tightening torque 64 53 1AZ.
Release screws (1) and remove refrigerant lines.
Tightening torque 64 53 5AZ .
Remove refrigerant line from double pipe holder (2).
Installation:
Replace sealing rings.
Use special tool 00 9 030 to mount sealing rings without damaging them.
After installation: