61 61 081 Replacing (removing and installing) left or right windscreen wiper arm

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

61 6 060

IMPORTANT: Do not bend windscreen wiper arm during removal (risk of breakage).

Remove cover cap for wiper arm (1) on left or right.

Release nut underneath. Tightening torque 61 61 11AZ .

Fig 1: Identifying Windscreen Wiper Arm Underneath Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Detach wiper arm (1) with special tool 61 6 060.

Installation:

Adjust position of wiper arm in question in rest position (measured between wiper lip and top edge of cowl panel cover).

Then tighten down wiper arm and check ADJUSTMENT DIMENSIONS of relevant wiper arm again.

Fig 2: Disconnecting Wiper Arm Using Special Tool (61 6 060)

Courtesy of BMW OF NORTH AMERICA, INC.