12 63 520 Replacing main relay (M62, M54)

Switch off ignition.

Connect DIS Tester.

Detach sealing strips (1).

Fig 1: Detaching Sealing Strips

Courtesy of BMW OF NORTH AMERICA, INC.

Turn tommy bar through approx. 90°.

Remove cover.

Fig 2: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release lock (1).

Remove air funnel (2) towards top.

Fig 3: Removing Air Funnel

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws.

Tightening torque, refer to 12 90 4AZ in ENGINE ELECTRICAL SYSTEM - TIGHTENING TORQUES - X5 4.6L .

Remove cover (1) on control unit box.

Fig 4: Removing Control Unit Box Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Insert fixtures (1) of cover for control unit box in openings (2).

Fig 5: Installing Cover For Control Unit Box

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 6: Identifying Digital Motor Electronics Main Relay And Engine Fuses

Courtesy of BMW OF NORTH AMERICA, INC.

Notes on troubleshooting  :

If the starter motor cranks the engine during the starting sequence but the engine fails to fire, then:

1. Check engine fuses
2. If fuses are blown, replace them completely with fuse holder
3. Find out why fuses have blown

   Continue troubleshooting as per DIS instructions.