34 21 Rear Brake Discs E71 / E72
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Installation of new brake pads is approved only provided that the brake disc thickness exceeds the specified dimension for "MIN TH" (see table).
Brake discs must be replaced when they reach the nominal thickness (see table) minus 2.4 mm!
(Not applicable to perforated brake discs and M vehicles)
.
Applies only to M vehicles and perforated ventilated brake discs:
The brake discs must be replaced once they wear to the nominal specified thickness (see table) minus 1.6 mm!
.
Depending on:
different brake discs can be fitted
The brake discs must always be assigned by way of the relevant vehicle identification number and the Electronic Parts Catalogue!
Brake discs must be replaced when they reach the nominal thickness (see table) minus 2.4 mm!
(Not applicable to perforated brake discs and M vehicles)
.
Applies only to M vehicles and perforated ventilated brake discs:
The brake discs must be replaced once they wear to the nominal specified thickness (see table) minus 1.6 mm!
.
Depending on:
- Engine type
- Transmission version
- Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.)
different brake discs can be fitted
The brake discs must always be assigned by way of the relevant vehicle identification number and the Electronic Parts Catalogue!
REAR BRAKE DISCS SPECIFICATIONS
| Different thicknesses on brake linings | Max. mm | 0.01 |
| Nominal size (diameter x thickness) | mm | 385x24 |
| Nominal size (diameter x thickness) | mm | 345x24 |
| (MIN TH) is stamped in brake disc chamber | mm | 22.4 |
| Nominal size (diameter x thickness) | mm | 320x20 |
| (MIN TH) is stamped in brake disc chamber | mm | 18.4 |
| Wear warning from residual lining thickness | mm | 3.7 |