33-1300 Extractor

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

0492096 331300 Extractor MW

NOTE: (Rillex extractor) For bevel pinion and differential case (rear diff) / for installation of camshaft sprocket on crankshaft (M70) / for removing bearing inner race from drive flange (E36, E46) [released]

Fig 1: Identifying Extractor (0492096)

Courtesy of BMW OF NORTH AMERICA, INC.

Storage Location

Consisting of:

2 = 0492098 Washer
NOTE: (Disc) Replaced by 33 1 311. (0 492 107) [replaced]
3 = 0492099 Washer
NOTE: (Disc) Replaced by 33 1 311. (0 492 107) [replaced]
4 = 0492100 Washer
NOTE: (Disc) Replaced by 33 1 311. (0 492 107) [replaced]
1 = 0492097 Connector
NOTE: (Basic body) For transmissions S5D 260Z, S5D 310Z and S5D 320Z;Discontinued, only available via complete tool [cannot be ordered individually]
5 = 0492101 Synchronizing key
NOTE: (Thrust piece (old)) Discontinued, only available via complete tool [cannot be ordered individually]
6 = 0492102 Synchronizing key
NOTE: [Discontinued]
8 = 0492104 Synchronizing key
NOTE: [Discontinued]
9 = 0492105 Synchronizing key
NOTE: For rear axle differential and for installing the camshaft sprocket on the crankshaft (M70) Discontinued, only available via complete tool [cannot be ordered individually]
1 = 0492107 Washer
NOTE: (Disc) Discontinued, only available via complete tool [cannot be ordered individually]
2 = 0492108 Synchronizing key
NOTE: For pulling the bearing inner race off the drive flange - Series: E36/5 Discontinued, only available via complete tool [cannot be ordered individually]
7 0492103 = Synchronizing key
NOTE: Discontinued, only available via set. Discontinued, only available via complete tool [cannot be ordered individually]