31-1000 Device

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

0491850 311000 Device MW

NOTE: For removing and installing the rubber mount in the front axle support and in the wishbones and for press-fitting the taper roller bearing onto the differential case of the rear axle differential. [Discontinued]

Fig 1: Identifying Device (0491850)

Courtesy of BMW OF NORTH AMERICA, INC.

Storage Location

Consisting of:

= 0491851 Spindle
NOTE: With 2 nuts and 2 window glasses [discontinued]
= 0491852 Bush
NOTE: (Slip bush) For installing the rubber mount in the front axle support [discontinued]
= 0491853 Bush
NOTE: (Bush) For removing the rubber mount in the front axle support and for removing and installing the rubber mount in the wishbones and for press-fitting the taper roller bearing of the rear axle differential [discontinued]
= 0491854 Pipe
NOTE: (Support tube) For installing the rubber mount in the front axle support, series: E12 [discontinued]
= 0491855 Washer
NOTE: (Flanged washer) For centering of threaded spindle and as a support disc for removing and installing the rubber mount in the front axle support and in the wishbones, series: E12 [discontinued]
= 0491856 Synchronizing key
NOTE: For removing and installing rubber mount in front axle support, series: E12 [discontinued]
= 0491857 Bush
NOTE: For installing the rubber mount in the front axle support, series: E12 [discontinued]
= 0491858 Bush
NOTE: (Bush) For installing the rubber mount in the front axle support and thrust piece, for removing and installing the rubber mount in the wishbones [discontinued]
= 0491859 Bush
NOTE: (Bush) Discontinued, only available via complete tool [cannot be ordered individually]