84 50 060 Removing and installing/replacing Bluetooth antenna (up to 03/2010)

Necessary preliminary tasks: 

• Remove BOTH TRIM PANELS FOR ROOF PILLAR
• Remove BOTH REAR GRAB HANDLES
• Remove INTERIOR ROOF LIGHT
• Remove UPPER B-PILLAR TRIM
• Remove BOTH FRONT GRAB HANDLES

Remove auxiliary brake light trim (1) in direction of arrow from headlining (2).

Fig 1: Removing Supplementary Brake Light Cover From Molded Roofliner

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip headlining.

Fig 2: Locating Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Fig 3: Identifying Interior Roof Light Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Partially lower headlining (1).

Installation note: 

Make sure edge protection (2) is correctly seated.

Fig 4: Identifying Lower Headlining And Edge Protection

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Unclip Bluetooth antenna (2) and remove.

Fig 5: Identifying Bluetooth Antenna And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.