63 12 870 Replacing ignition unit for left xenon headlight
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Version with xenon headlights:
Danger to life due to high voltage! Therefore disconnect all components from voltage supply before removal.
Danger to life due to high voltage! Therefore disconnect all components from voltage supply before removal.
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.
Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS)
Necessary preliminary tasks:
- Remove LEFT HEADLIGHT
Release screws (1) on cover (2) and remove from headlight (3).
Tightening torque: see 4AZ in 63 12 HEADLIGHT .
Installation note:
The housing cover must be locked correctly.
Check seal.
Replace the housing cover, if necessary.
Observe NOTES FOR REPLACING THE PROTECTIVE CAP .
Disconnect plug connection (1) on ignition unit with bulb (3).
Unlock retainer (2) and remove ignition unit with bulb (3) in direction of arrow.