63 11 550 Removing and installing/replacing headlight driver module
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Version with xenon lighting system: Danger to life due to high voltage! Therefore disconnect all components from voltage supply before removal.
Work on the entire xenon lighting system (ignition unit, control unit and lamp) may only be carried out by specialist personnel.
Work on the entire xenon lighting system (ignition unit, control unit and lamp) may only be carried out by specialist personnel.
Necessary preliminary tasks:
- Remove FRONT LEFT WHEEL ARCH TRIM
Release screws (1) on headlight (2).
Tightening torque: see 3AZ in 63 12 HEADLIGHT .
Remove headlight driver module (3) in direction of arrow.
Unlock plug connection (1) and disconnect in direction of arrow from headlight driver module (2).
Installation:
When fitting, make sure headlight driver module (1) is correctly seated on sealing sleeve (2).
Replacement:
Teach in headlight driver module (1) via vehicle diagnosis.
- Service functions
- Body
- Lights
- Learning turn signal indicator