35 11 000 Removing and installing (replacing) complete bearing support for foot pedal

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After completion of work, carry out function check.

Necessary preliminary tasks:

Remove BRAKE SERVO

Release screws (1).

Remove control units from holder (2). Plugs remain connected.

Fig 1: Identifying Control Units Holder And Screws

G06894910

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Installation note:

Replace self-locking nut.

Tightening torque: see 2AZ in 35 11 PEDAL ASSEMBLY CONSOLE

Remove bearing support (2).

Fig 2: Identifying Bearing Support And Nut

G06894911

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip line (1).

Disconnect plug connection (2).

Replacement:

Modify brake light switch
Modify holder for control units

Fig 3: Identifying Plug Connection And Line

G06894912

Courtesy of BMW OF NORTH AMERICA, INC.