3.1 Preparation of the surface on the vehicle (series status)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, 2012 BMW 760Li, and 2011 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
- Establish a level bonding surface (e.g. grinding). Do not remove the series primer entirely.
- Do not grind/sand bonding surfaces .
- If necessary, pre-clean bonding surfaces with cavity sealing wax remover.
Clean bonding surfaces with cleaning agent R1.
- Allow cleaned surfaces to dry for approx. 5 minutes.
Bonding surfaces must be completely dry.