65 50 025 Removing and installing/replacing video switch

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

NOTE: Follow instructions for HANDLING OPTICAL FIBRES .

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE LEAD
Remove LUGGAGE COMPARTMENT WHEEL ARCH TRIM on left.

NOTE: Video switch is located on the back of the bracket for the TV module.

Release screws (1) and nuts (2).

Remove TV module (3) including bracket.

Fig 1: Identifying TV Module, Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Unfasten plug connection (2) and disconnect.

Remove video switch (3).

Fig 2: Identifying Video Switch, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.