65 24 020 Removing and installing/replacing left or right blocking circuit

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove TRIM PANEL FOR ROOF PILLAR AT REAR .

Equipment specification with rear A/C system .

Release screw (1).

Slide lock (2) in direction of arrow.

Feed out air duct (3).

Fig 1: Sliding Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

If necessary, release screw (4).

Unlock plug connections (2) and disconnect.

If necessary, disconnect plug connection (5).

Remove blocking circuit (3) from C-pillar.

Installation note:

Position blocking circuit (3) so that positioning pin on back engages in associated bore hole.

Fig 2: Identifying Screw, Plug Connections, Blocking Circuit And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

Remove TRIM PANEL FOR ROOF PILLAR AT REAR .

Release screw (1).

If necessary, release screw (4).

Unlock plug connections (2) and disconnect.

If necessary, disconnect plug connection (5).

Remove blocking circuit (3) from C-pillar.

Installation:

Position blocking circuit (3) so that positioning pin on back engages in associated hole.

Fig 1: Identifying Screw, Plug Connections, Blocking Circuit And Screw

Courtesy of BMW OF NORTH AMERICA, INC.