65 77 532 Removing and installing/replacing front left sensor (US version only)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT LEFT WHEEL ARCH COVER

NOTE: This work step varies according to engine type.

Release screw (1) on auxiliary radiator bracket (2).

Remove holder (2) and carefully place to one side.

Installation:

Fig 1: Identifying Auxiliary Radiator Bracket, Screw And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Holder (2) must be correctly seated in the designated guides.

Release screws (1) on lock carrier (2).

Tightening torque: see 2AZ in 65 77 AIRBAG TRIGGERING CONTROL .

Feed out sensor (3).

Unfasten plug connection (2) and disconnect.

Installation:

Make sure sensor (3) is in correct installation position.

Sensor surface must point upwards.

Plug connection (2) must point in opposite direction to direction of travel.

Fig 2: Identifying Sensor, Lock Carrier, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.