72 11 050 Removing and installing/replacing front anchor fitting tensioner (driver's seat only)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioners.
Improper handling can lead to activation of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.
Improper handling can lead to activation of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.
Switch off ignition!
NOTE:
A triggered anchor fitting tensioner can be recognized from the wrapped seat belt strap around the shaft.
If the anchor fitting tensioner has not been triggered, the shaft is visible.
Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of hardening)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Necessary preliminary tasks:
- Remove UPPER RAIL COVER
- Remove OUTER COVER
Cut cable straps.
Installation note:
Replace faulty cable straps.
Plug connection must not be under tension.
UNLOCK AND DISCONNECT plug connection (1).
Release screw (2).
Installation note:
Replace screw (2).
Tightening torque 72 11 06AZ .
Remove anchor fitting tensioner.
Release screw (1).
Tightening torque 72 11 07AZ .
Remove lock washer.
Pull seat belt strap (2) out of end fitting tensioner.