66 53 010 Calibrating reversing camera
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Calibration of reversing camera must be carried out after the following work:
- Removal and installation/replacement of reversing camera
- Body repair work at rear end of vehicle
- Adjusting work at tailgate
IMPORTANT:
Follow instructions and specifications in procedure
.
To obtain an optimum result, always adhere to the following conditions:
To obtain an optimum result, always adhere to the following conditions:
- Vehicle standing level on headlight aiming station
- Correct tire pressure (see label on car).
- Vehicle is free of load
- Rear seat bench is unoccupied
- Do not swap seats during calibration
- Steering wheel in straight-ahead position
- Do not move steering wheel
NOTE:
Also switch on reversing camera by means of PDC button.
Calibration can only be carried out with the BMW diagnosis system.
Use of a special tool is no longer required from 03/2011!
Service functions:
- Complete vehicle
- Body
- Camera systems