66 32 020 Removing and installing/replacing sensor for lane change warning on left or right: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove REAR BUMPER PANEL
Disconnect plug connection (1).
Unfasten screws (2).
Remove sensor (3).
IMPORTANT:
If, in the event of side damage to the vehicle, it is not necessary to replace the tail panel, observe the following points:
Fit middle bumper panel guide on undamaged side
Use middle bumper panel guide as a gauge in order to check or correct the position of the remaining connecting points.
Middle bumper panel guide must be a to be fitted without tension.
Fit middle bumper panel guide on undamaged side
Use middle bumper panel guide as a gauge in order to check or correct the position of the remaining connecting points.
Middle bumper panel guide must be a to be fitted without tension.