66 51 030 Removing and installing/replacing camera for Lane Departure Warning: Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Expand two-part mirror base cover (1) by pressing from below and detach.

Feed out two-part mirror base cover (1) and remove.

NOTE: Latch mechanisms of two-part mirror base cover (1) must not be damaged.

Fig 1: Disconnecting Two-Part Mirror Base Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Slide camera (1) in direction of arrow out of mounting.

Disconnect plug connection (2).

Installation note:

Make sure camera (1) is firmly seated in mounting.

Fig 2: Sliding Camera Out Of Mounting

Courtesy of BMW OF NORTH AMERICA, INC.