Performing initial operation with test run
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of injury!
Vehicle executes heavy rolling motions during initial operation! Therefore observe the following instructions without fail:
Vehicle executes heavy rolling motions during initial operation! Therefore observe the following instructions without fail:
- Do not allow any persons to remain in the vehicle or directly on the vehicle
- Keep the vehicle doors closed.
- Maintain a safety distance around the vehicle of 1 meter to persons, objects, walls etc.
- Vehicle must be standing horizontally with all wheels on a firm surface
- Do not under any circumstances carry out initial operation on a lifting platform, wheel alignment analyzer or similar!
- Avoid heavy loads
- Check load; if necessary, remove load from the vehicle
- Bring engine up to operating temperature
- Connect vehicle to DIS or MoDiC
- Start initial operation in SERVICE FUNCTIONS. Follow instructions in Diagnosis and Information System.
- Check fill level again with engine stationary and if necessary top up oil to 80° mark.