LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 3409 (Integrated Suspension Systems - Repair) >> General >> 37 10 001 Initial operation with test run of Dynamic Drive >> Bleeding hydraulic circuit

Bleeding hydraulic circuit

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean fluid reservoir and its immediate surroundings with cap closed
  2. Check and correct fill level
    NOTE: The fill level must not be above the "MAX" mark (80 °C) with the engine at normal operating temperature.

    When filling observe temperature indication of dipstick.

    Hydraulic fluid: Pentosin CHF11S

  3. Start engine
  4. Turn steering wheel left and right twice in each case up to full lock; if necessary, top up hydraulic fluid (e.g. if hydraulic system is completely drained)
  5. Move steering wheel to straight-ahead position and turn off engine
  6. Check and correct fill level with engine stopped
  7. Check reworked components on hydraulic system for leaks
scientia non olet · About LEMON Manuals