37 10 001 Start-up with test run of Dynamic Drive (EPS steering gear): Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Service function start-up of Dynamic Drive must be carried out after:
- Work on the Dynamic Drive system which involved opening hydraulic lines
- Replacing / programming / encoding Dynamic Drive control unit (ICM-V-High)
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Using contaminated auxiliary materials to add fluid may introduce dirt particles into the oil reservoir and significantly reduce the service life of ARS. Do not use any filler funnels or similar!
Use only Pentosin CHF11S from original containers!
The fill level may only be checked or adjusted when the engine is stopped! Adjust fluid level if possible in middle between 20° and 80° C.
Ensure that the cap is fully screwed in prior to the fill level check.
Using contaminated auxiliary materials to add fluid may introduce dirt particles into the oil reservoir and significantly reduce the service life of ARS. Do not use any filler funnels or similar!
Use only Pentosin CHF11S from original containers!
The fill level may only be checked or adjusted when the engine is stopped! Adjust fluid level if possible in middle between 20° and 80° C.
Ensure that the cap is fully screwed in prior to the fill level check.
NOTE:
To avoid mix-ups when filling with hydraulic fluid, mark the fluid reservoirs or their caps with identification marks.