37 13 127 Removing and installing/renewing pressure lines for valve block (short): Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: DANGER OF POISONING if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Do not draw off hydraulic fluid (risk of contamination).
Close off line connections with seal plug. 32 1 270

Recycling:

Catch and dispose of hydraulic fluid in a suitable expansion tank.

Necessary preliminary tasks:

Remove FRONT RIGHT WHEEL ARCH COVER REAR SECTION
Release front right UNDERBODY PANELLING

IMPORTANT: Pressure lines and connections on valve block must be fitted with suitable seal plugs immediately after dismantling!

Release screws (2) for pressure lines on valve block.

Tightening torque 37 13 3AZ .

Fig 1: Identifying Hydraulic Line Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw connections (1) and (2) and detach line.

Tightening torque 37 13 5AZ .

Fig 2: Identifying Screw Connections

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: When assembling, make sure that in succession only the seal plugs of the line to be fitted are removed.
When fitting lines, do not tilt connectors (sealing rings!) and connect fully before screwing.
Do not replace sealing rings on hydraulic lines.
Replace affected line if sealing ring is damaged.