37 13 125 Removing and refitting/replacing pressure line on swivel motor VA2: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
DANGER OF INJURY if oil comes into contact with eyes and skin!
DANGER OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Do not draw off hydraulic fluid (risk of contamination).
Close off line connections with seal plug. 32 1 270
Do not draw off hydraulic fluid (risk of contamination).
Close off line connections with seal plug. 32 1 270
Recycling:
Catch and dispose of hydraulic fluid in a suitable expansion tank.
Necessary preliminary tasks:
- Remove front right wheel arch cover. See WHEEL ARCH COVER (FRONT SECTION) and WHEEL ARCH COVER (REAR SECTION) .
- LOWER FRONT AXLE
IMPORTANT:
Pressure line and connection on valve block must be fitted with suitable seal plugs 32 1 270
immediately after removal!
Unfasten screw connection (1).
Tightening torque 37 13 5AZ .
Unlock plastic holder (1) and disengage line.
Release screws (1) from line clip on front axle support and remove clip.
Tightening torque 37 13 7AZ .
Release screw (2).
Remove pipe.
Tightening torque 37 13 4AZ .
IMPORTANT:
Note installation position of rubber spacer (1).
Make sure pressure lines are laid without tension.
Make sure pressure lines are laid without tension.
IMPORTANT:
When assembling, make sure that in succession only the seal plugs of the line to be fitted are removed.
When fitting lines, do not tilt connectors (sealing rings!) and connect fully before screwing.
Do not replace sealing rings on hydraulic lines.
Replace affected line if sealing ring is damaged.
When fitting lines, do not tilt connectors (sealing rings!) and connect fully before screwing.
Do not replace sealing rings on hydraulic lines.
Replace affected line if sealing ring is damaged.