Removing the rubber mount for the bottom module carrier

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Release screws (1) on left and right on holder for module carrier.

Tightening torque: see 10AZ in 17 10 RADIATOR, EXPANSION TANK

Fig 1: Identifying Module Carrier Holder Screws

G08504299

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Picture shows left side. Procedure on right side identical.

Lift module carrier (1) upwards slightly.

Disengage holder with rubber mount for module carrier (2) from bumper support (3).

Fig 2: Lifting Module Carrier

G08504302

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Picture shows left side. Procedure on right side identical.

For purposes of clarity, the graphic shows the front bumper removed.

Pull holder with rubber mount for module carrier (1) off module carrier (2), feed out and remove.

Installation note:

Apply mounting lubricant to the new rubber mounts prior to installation.

Fig 3: Removing Module Carrier Holder

G08504303

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.