31 35 000 Removing and installing/replacing front anti-roll bar

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT UNDERBODY PROTECTION .
Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR .
F12 All-wheel drive vehicle: Remove the front stiffening plate.
F06 M6, F12 (without all-wheel drive), F13, F10-M5: Remove stiffening plate.

Release screws (1).

Tightening torque: see 1AZ in 31 35 ANTI-ROLL BAR

Remove anti-roll bar (2) downwards.

Fig 1: Identifying Anti-Roll Bar And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Identifying Retaining Bracket Nose And Lower Mounting Plate Points To Rubber Bearing Curve

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace screws.

Pay attention to installation location of retaining bracket and mounting plate!

Nose (1) on retaining bracket must point left in direction of travel
Curve (2) on lower mounting plate points to rubber bearing