Trim the bumper panel to size

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Remove BUMPER PANEL .

Mark points (A to D) on left and right of untrimmed bumper panel (1).

Measurements are taken from the slats of the ornamental grille (2).

= 65 mm
= 65 mm
= 75 mm
= 90 mm

Fig 1: Identifying Ornamental Grille Measurements
Courtesy of BMW OF NORTH AMERICA, INC.
= Perpendicular to point (D)

Connect points (A to E) and cut out area (1).

Place front spoiler on cut bumper panel and check for accuracy of fit; if necessary, rework bumper panel.

After completion of work, deburr the cutting edges.

BUMPER PANEL must now be attached.

Fig 2: Identifying Connect Points (A To E) And Cut Out Area

Courtesy of BMW OF NORTH AMERICA, INC.