Pulling cutting wire into vehicle

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Grip wire with pliers (If access is difficult: using wire starter 2 150 267, feed wire through adhesive bead.)
Wire end (1) must be bent towards window glass.
Heat wire end (1) and use it to pierce adhesive bead (2).
Pull approximately half of the wire into the passenger compartment

Fig 1: Identifying Wire End And Pierce Adhesive Bead
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: When using the separating cord, always pull it in using the wire starter 2 150 267.