3.2 Treatment of adhesive area in body aperture
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
- Touch up PAINTWORK DAMAGE on body aperture with BMW multibase filler.
- Clean with cleaning agent R2
- Observe an air drying time of at least 5 minutes (at least 15 minutes when applied to residual adhesive bead)
- Apply paint activator (blue stick) to paint and then wipe dry with a paper towel.
- Observe an air drying time of at least 1 minute (at least 10 minutes when applied to residual adhesive bead)
IMPORTANT:
Do not use Sika remover 208 for cleaning in the adhesive area.
Bond two yellow plastic adhesive tapes (1) approx. 400 mm in length to the roof.
(A) = 250 mm
Only the yellow plastic adhesive tape may be used to fix the window glass.
The glass will slip down if other adhesive tapes are used.
Window glass slippage will result in leaks and wind noises.
After completing the paint work, the paint must be fully hardened before the plastic adhesive tapes are applied.