Observe before installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Observe minimum tire air temperature of +15 °C!
Clean wheel/tire
Check wheel rim for burrs, wear and other damage
Clean tire beads and check for evidence of damage
Check RDC sensor for damage
Renew tire valve

Before installation:

IMPORTANT: Apply LUBRICANT to inside of top tire bead (1) and to outside of top and bottom tire sidewall (2) up to top decorative line!

Fig 1: Identifying Top Tyre Bead And Bottom Tyre Sidewall

Courtesy of BMW OF NORTH AMERICA, INC.

Apply LUBRICANT over entire well area.

Lever sensor spare.

Fig 2: Applying Lubricant Over Entire Well Area

Courtesy of BMW OF NORTH AMERICA, INC.

Installation of bottom tire bead:

Grip wheel and lay on tire.

IMPORTANT: Apply a light coating of ANTISEIZE COMPOUND to fitting head.

Fig 3: Identifying Light Coating Applying Area On Fitting Head

Courtesy of BMW OF NORTH AMERICA, INC.

Position fitting head (1) as pictured.

IMPORTANT: Make sure tire is correctly positioned on fitting head. Position tire bead in relation to mounting head (1) in accordance with equipment manufacturer's specification.

Position sensor (RDC) (3) and valve min. 10-15 cm before traction point/catching point (2).

Sensor must not be subjected to load.

Allow fitting machine to rotate slowly.

Guide tire in direction of rotation and press towards wheel drop center.

Fig 4: Identifying Mounting Head, Traction Point/Catching Point And Position Sensor (RDC)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation of top tire bead:

Position sensor (1) in relation to mounting head (2) as pictured.

IMPORTANT: Make sure tire is correctly positioned on fitting head. Position tire bead in relation to mounting head (2) in accordance with equipment manufacturer's specification.

Position sensor (RDC) (1) and valve min. 10-15 cm before traction point/catching point.

Sensor must not be subjected to load.

Coat bead holding-down element (3) with LUBRICANT and insert.

Fig 5: Identifying Position Sensor, Mounting Head And Bead Holding Down Element

Courtesy of BMW OF NORTH AMERICA, INC.

Allow fitting machine to rotate slowly.

Insert additional bead holding-down elements (1) to hold the tire bead in wheel drop center.

The last part of the tire bead should jump over the rim flange in the sensor area.

IMPORTANT: Perform fitting in stages, take short breaks and relieve tension.

Avoid heavy deformations at the traction point.

Do not squash belt edge and side walls through hold-down devices.

Never use a tire iron as a holding-down element.

Fig 6: Identifying Bead Holding-Down Elements

Courtesy of BMW OF NORTH AMERICA, INC.