12 61 280 Removing and installing/replacing oil pressure sensor (N74)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Scalding hazard!

Only perform this task on an engine that has cooled down.

Necessary preliminary tasks:

Turn off ignition
Remove rear UNDERBODY PROTECTION

Installation location: Oil pressure sensor is located above the oil filter housing.

Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.

Unlock plug (1) and remove.

Release and remove oil pressure sensor (2).

Tightening torque: see 1AZ in 12 61 ENGINE OIL PRESSURE, OIL CONDITION DISPLAY .

Installation:

Check engine oil level. Top up engine oil if level is too low.

Fig 1: Identifying Oil Pressure Sensor With Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.