33 55 000 Removing and installing/replacing rear anti-roll bar

Necessary preliminary tasks: 

• Remove both ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR 

Release screws (1).

Tightening torque: see 1AZ in 33 55 ANTI-ROLL BAR

Installation note: 

Replace screws.

Turn anti-roll bar (2) and remove sideways.

Fig 1: Identifying Anti-Roll Bar And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

• Check BOTH RUBBER MOUNTS FOR DAMAGE  and replace if necessary.
• Pay attention to correct installation position when installing anti-roll bar..
• The bend of the anti-roll bar must point upwards in the anti-roll bar to anti-roll bar link area.