11 11 Engine block
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - ENGINE BLOCK
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Bearing cap to crankcase (ASA collar screw) | N74 | M11x102 | Replace screws | |
| Jointing torque | 20 Nm | |||
| Torque angle | 100 ° | |||
| 2AZ Bearing cap to crankcase (ASA collar screw 10.9) | N74 | M8x70 | Replace screws | |
| Jointing torque | 10 Nm | |||
| Torque angle | 55 ° | |||
| 3AZ Threaded support sleeves | N74 | M16x1.5 | Jointing torque | 6 Nm |
| 4AZ Angled screw connection to crankcase | N74 | M8x37 | Flanged head screw 10.9 | 34 Nm |
| 5AZ Spacer bolt, oil pump | N74 | M8 | 34 Nm | |
| 6AZ Screw plug, water drain | N74 | M14x1.5 | Replace seal | 25 Nm |
| 7AZ Oil nozzle to crankcase | N74 | M4 | 3 Nm | |
| 8AZ Plug, oil pressure switch position (as required) | N74 | M12x1.5 | 20 Nm | |
| 9AZ Oil drain pipe to crankcase | N74 | M15x1 | 10 Nm | |
| 10AZ Special tool 11 6 160 to crankcase | N74 | M10 | 38 Nm | |
| 11AZ Special tool 11 6 160 to 00 2 322 | N74 | M10x35 | 80 Nm | |
| 12AZ Special tool 00 2 321 to special tool 00 2 301 | N74 | M14x120 | 130 Nm |