51 71 Seals and Loose Body Parts
WARNING: This page is about a different car, the 2003 BMW X5, 2002 BMW X5, 2001 BMW X5, and 2000 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
51 71 SEALS AND LOOSE BODY PARTS TIGHTENING SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1 AZ Front spoiler to bumper | E36 / M3 | 3 N.m | ||
| 2AZ Rear spoiler | E34 / Touring, E36 / Z3 Coupe / M Coupe | M6 | 6 N.m | |
| E36 / M3 | M6 | 7 N.m | ||
| E53 | 3 N.m | |||
| E83 | M6 | 10 N.m | ||
| E61 | 8 N.m | |||
| E91 | Screw | 3 N.m | ||
| Nut | 7 N.m | |||
| 3AZ Reinforcement plate to front axle support/engine carrier | E46 without AWD / E85 | Replace screws | ||
| Jointing torque | 59 N.m | |||
| Torque angle | 90° | |||
| 4AZ Tension strut in engine compartment | E85 | Jointing torque | 30 N.m | |
| Torque angle | 90° | |||
| E60 / E61 / E63 / E64 | M8 | Screw connection again | 20 N.m | |
| New component / initial screw connection | 25 N.m | |||
| E83 | M8 | 19 N.m | ||
| E87, E90, E91 | M10 | Replace screws | ||
| Jointing torque | 40 N.m | |||
| Torque angle | 60° | |||
| E87, E90, E91 | M12x1.5 | Replace screws | ||
| Jointing torque | 100 N.m | |||
| Torque angle | 90° | |||
| 5AZ Reinforcing plate/ tension strut to rear axle | E85 / E46 / Convertible | M10 | Replace screws | |
| Jointing torque | 59 N.m | |||
| Torque angle | 90° | |||
| 6AZ Reinforcing plate to rear axle | E85 | M8 | 21 N.m | |
| 7AZ Tension strut to rear axle | E46/ Convertible | M8 | 24 N.m | |
| E60 M5 / E63 M6 | M8 | 21 N.m | ||
| E61 / E64 / E91 | M12 | Replace screws | ||
| Jointing torque | 100 N.m | |||
| Torque angle | 90° | |||
| E61 / E64 | M8 | Nut | 19 N.m | |
| E91 | M10 | 50 N.m | ||
| E85 | Replace nut | 24 N.m | ||
| 8AZ Cross-member, A-pillar, to mounting | E52 | M8 | 19 N.m | |
| 9AZ Cross-member, A-pillar, middle | E52 | M8 | 10 N.m | |
| 10AZ Strut to cardan tunnel | E52 | M8 | 19 N.m | |
| 11AZ Cross-member, A-pillar, bottom, to mounting | E52 | M6 | 11 N.m | |
| 12AZ Support tube to support, steering column upper section | E65 / E66 / E67 | M8 | 21 N.m | |
| E87 / E90 / E91 | M8 | 19 N.m | ||
| 13AZ Support tube to body | E85 | M8 | 19 N.m | |
| 14AZ Heater to support tube | E85 / E87 / E90 / E91 | 4 N.m | ||
| 15AZ Support tube to body | E60 / E61 / E63 / E64 / E87 / E90 / E91 | M8 | 21 N.m | |
| 16AZ Take-up, cover, sill to body | E83 | M8 | 5 N.m | |
| 17AZ Structural tension strut, front | E61 / E64 | M12 | Replace screws | |
| Jointing torque | 100 N.m | |||
| Torque angle | 90° | |||
| E61 / E64 | M6 | Replace screws | ||
| Jointing torque | 8 N.m | |||
| 18AZ Cross strut/rear | E61 / E64 | M10 | Nuts | 41 N.m |
| Screws | 59 N.m | |||
| 19AZ Bracket, handle, to body | E87 / E90 / E91 | 3.5 N.m | ||
| 20AZ Multifunction pan to body | E87 / E90 / E91 | 8 N.m | ||
| E60 / M5 | 3 N.m | |||
| 21 AZ Bracket, suspension, dividing net to body | E91 | 11 N.m | ||
| 22AZ Protective mat/protective cover to body | E60 / Security | M6 | Screw | 10 N.m |