72 11 070 Removing and installing/replacing front lower belt fitting (belt tensioner), driver's seat
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove FRONT SEAT, DRIVER'S SIDE
Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
UNLOCK AND DISCONNECT plug connections (1).
Release screw (1).
Installation:
Replace screw (1).
Tightening torque 72 11 03AZ .
Remove seat belt tensioner.
Installation:
Belt tensioner is coded against incorrect installation.