51 31 241 Removing and installing/replacing rear window cover (top)

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove REAR WINDOW

Observe NOTE on component bonding with adhesive tape!

Detach cover (1).

Remove remnants of adhesive tape (2).

Clean bonding surface.

Air drying time: ≥ 1 minute

IMPORTANT: Adhesive area must be dry and free from dust and grease.
Once it has been cleaned, do not touch the adhesive area with bare hands.

Fig 1: Identifying Cover And Adhesive Tape

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Pre-treat adhesive area with Sika-Aktivator-205 applicator.

Air drying time: ≥ 1 minute

Reposition lever (1) and open special tool 51 3 320 .

Fig 2: Repositioning Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off protective film (2) in stages from adhesive tape.

Insert cover (1) in guide pulleys (3).

Fig 3: Inserting Cover In Guide Pulleys

Courtesy of BMW OF NORTH AMERICA, INC.

Place special tool with contact rollers (1) up against upper window edge.

Align cover to window outer edge.

Fit cover and visually check for perfect seating.

Fig 4: Placing Special Tool With Contact Rollers

Courtesy of BMW OF NORTH AMERICA, INC.

Reposition lever (1) and close special tool.

Make cover (3) is correctly seated in guide pulleys (2).

Fig 5: Repositioning Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Continue to pull off protective film (1) in stages from adhesive tape.

Run special tool with handwheel over entire upper window edge.

Fig 6: Pulling Protective Film

Courtesy of BMW OF NORTH AMERICA, INC.