64 11 823 Replacing actuator drive for right rear cabin air blending flap

Necessary preliminary tasks: 

• Remove INSTRUMENT PANEL TRIM

Position of actuator drive: 

OVERVIEW OF ACTUATOR DRIVES ON HEATER/AIR CONDITIONER 

Release screws (1).

Installation: 

Replace screws.

Take off holder (2).

Fig 1: Identifying Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip connector piece (1) and slide downwards.

Installation: 

Latching of connector piece (1) must be felt.

Fig 2: Disconnecting Connector Piece

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove air vent duct (2).

Installation: 

Ensure cable routing along air vent duct (2) is correct

Fig 3: Identifying Air Vent Duct And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove actuator drive (2) and unlock and disconnect associated plug connection.

Fig 4: Identifying Actuator Drive And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Servomotors must be re-addressed in the event of replacement!

Addressing can only be carried out with the BMW diagnosis system.

Service functions:

• Body
• Heating and A/C function
• Flap motors
• Re-address flap motors