Removing the rubber mount for the bottom module carrier

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

Release screws (1) on left and right on holder for module carrier.

Tightening torque 17 10 10AZ .

Fig 1: Identifying Holder Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Picture shows left side. Procedure on right side identical.

Lift module carrier (1) upwards slightly.

Disengage holder with rubber mount for module carrier (2) from bumper support (3).

Fig 2: Disengaging Module Carrier Holder From Bumper Support

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Picture shows left side. Procedure on right side identical.

For purposes of clarity, the graphic shows the front bumper removed.

Pull holder with rubber mount for module carrier (1) off module carrier (2), feed out and remove.

Installation note:

Apply mounting lubricant to the new rubber mounts prior to installation.

Fig 3: Removing Module Carrier Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.